The tp link and is powered by a POE injector, which is plugged into a power strip along with the 6250 AC plug. It connects to a TP Link EAP225 via ethernet. The other 6250 was installed at the end of the dock coax run. I installed the ECB6250 with the included splitter off of the main wall coax and via ethernet to the the AC1300. Its spec sheet says its DOCSIS3.1, but Spectrum says that the max speed they can provide is 300Mbps.so I suspect its running on 3.0 The modem's connected to the router (AsusAC3100) WAN. Connect a second HTEM4 Coax to Ethernet Adapter into any Ethernet device you want to connect to the MoCA network. Plug in the Ethernet cord to your modem, router or access point. Plug in the power supply to a power outlet. Currently it splits at the wall (BAMF 5-2300 Splitter), with one cable going to the STB and one to the Modem (Ubee EU2251). MT7711 24X8 Cable Modem plus AC1900 Dual Band WiFi Gigabit Router plus 2 Phone Lines for Comcast® Xfinity® This Three-in-One 24x8 DOCSIS 3. Works right out of the box with easy set up: Plug the HTEM4 Coax to Ethernet Adapter in to an active coax cable outlet. You just need to pair the one and only MoCA adapter with your Xfinity router. Only the upper level outlet is being used. The setting up process will be easy and quick if you have a router to enable MoCA technology. None of the lower level plugs are in use. The line that runs into the house splits off into upper and lower levels. The coax is split with a Antronix 5-1000 splitter. Currently the TWC cable has a POE filter at the ONT, where it also splits into two main runs - one into the house and one towards the dock. I'm trying to setup a MoCa network at our lake house - from the home network to the dock.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |